Our service centre consists of specialized equipment’s and qualified ASET technicians and capacity of accommodating more than 100 cylinders at once.

BCD Servicing

Cylinder Servicing and Inspection

Cylinder Testing

We have a range of adapter to fit almost any cylinder thread size eg. M25, M18, DAN Oxygen Cylinders, Taper Threads etc. We maintain copies of the latest cylinder testing standards on our premises, tank inspection guide. This ensures that we can fully test your cylinder to the correct standard.

Dive Club Maldives uses the most advanced cylinder testing tools available when carrying out a visual inspection such as the Visual Plus 3 Eddy current NDT tester and an ultrasonic thickness gauge.

Compressed gas cylinders are designed with a safety factor that is measured by testing the cylinders with one of the following methods:

Non-water Jacket Volumetric Testing

Water Jacket Volumetric Testing

Proof Pressure Testing

We have a Volumetric Water Jacket hydrostatic test system capable of testing cylinders up to 10,000 psi 680 bar. Our hydrostatic test system has a working gauge, a master gauge and calibrated test cylinder, the working gauge is checked against the master gauge monthly and a calibration error chart is produced.

This chart lists the error that the working gauge is reading and an adjustment is made during test to ensure that the correct test pressure is applied.

At the beginning of everyday the hydrostatic test system is in use the system is checked by hydro statically testing a calibrated cylinder. If the test results are not accurate then the system is fully checked for any fault and the calibrated cylinder is re-tested until the fault is rectified.

By having a calibrated working gauge and a calibrated test cylinder you can be sure that should a cylinder fail the hydrostatic test (cylinders rarely fail the test) it is not due to faulty equipment.

Dive Club Maldives has a complete range of adapters and tools to be able to test most makes of Scuba diving and Scuba cylinders, if you have cylinders that need testing and the thread size is not listed here, please bring them in and we may be able to make an adapter to fit.

3/4-14 NPSM

7/8-16 NPSM

G3/4-14 BSP

25-2 mm Parallel

18-1.5 mm Parallel

1/2-inch NGT Taper

0.6-inch Taper

0.715-inch Taper

19.8 mm Taper